+ Reply to Thread
Results 1 to 1 of 1

Thread: For Sale -- Rockwell Delta Lathe Model 46-305

  1. Default For Sale -- Rockwell Delta Lathe Model 46-305

    Lathe = Model 1460, Stand = Model 1463, together they make up the Delta Rockwell 12" X 37" Wood Turning Lathe Model 46-305. It's D. of B. is Jan. '48, verified with Delta by the serial # 61-5066. New Original Equipment bearings replaced early '08Lathe = Model 1460, Stand = Model 1463, together they make up the Delta Rockwell 12" X 37" Wood Turning Lathe Model 46-305. It's D. of B. is Jan. '48, verified with Delta by the serial # 61-5066. New Original Equipment bearings replaced early '08.

    Name:  Lathe 012 (Small).jpg
Views: 3457
Size:  51.2 KB

    This is a pic of the day it was put into operation in my basement workshop. It is covered in pen shavings at this time but when dusted off would look like new again.

    Right angle tool support, 4 step motor pulley, 3" & 6" face plates, 4", 12", & 24" tool rests, floor stand for outboard tool rest, spindle steady, spur centre, cup centre etc. etc.

    Priced for quick sale $500.00 firm!

    Name:  Lathe 011 (Small).jpg
Views: 1774
Size:  41.1 KB

    Name:  lathe motor (small).jpg
Views: 1691
Size:  37.0 KB
    Last edited by Mack C. in Brooklin ON; 01-01-2010 at 06:46 PM.
    Mack C. in Brooklin (Whitby) ON
    It feels really great to sell a pen;
    It feels even greater to give one to a friend!

+ Reply to Thread

Similar Threads

  1. General or Delta 8" Jointer?
    By Bri in Mtl in forum Woodworking
    Replies: 10
    Last Post: 12-22-2009, 01:39 AM
  2. Delta SA350K Spindle Sander
    By Canadian Woodshop News and Review in forum Woodworking
    Replies: 0
    Last Post: 12-15-2009, 01:41 AM
  3. Tabled My First Craft Sale
    By Richard in Smithville in forum Off Topic
    Replies: 2
    Last Post: 11-22-2009, 09:27 PM
  4. Spring Pole Lathe
    By mwv in forum Woodworking
    Replies: 2
    Last Post: 11-10-2009, 03:05 AM
  5. Some 4 Sale & Some 4 Free!
    By aussie in forum The Swap Shop
    Replies: 0
    Last Post: 10-31-2009, 12:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts